Alpha Microsystems AM-649 Guida Utente Scaricare il pdf (Pagina 21)

To restore factory default settings (except IP address/subnet/Gateway) use

Menu 7

Tip: Press ENTER to move through the menu fields without changing them.

Top-tip: Ensure you save changes made in the above by selecting Menu 9

☺

5 Sending/Receiving data

The NetPort should now be enumerated on your LAN and can receive/send data according to

its standard serial settings:

• 9600b/sec, No parity, 8 bit data, 1 stop bit

• Handshaking set to CTS/RTS

If your RS232 equipment can communicate in this data format then all you need to do now is

open an application on a networked PC to send/receive.

5.1 If you do NOT have an application which can talk to a TCP/IP

Socket.

You have 2 options without creating a specific software application:

1. Use Com Port Redirector to assign a Virtual Com Port to the NetPort, you can then

use your existing application software to communicate via COMx over the Ethernet

without any TCP/IP knowledge. (where x is the Com Port number you have

configured in Redirector)

a) Install Com Port Redirector on the PC that the Virtual Com Port is required

using the NetPort CDROM.

b) Run Redirector by clicking

Start\Programs\Lantronix\Redirector\Configuration.

See the AMC-AN-LAN07 Com Port Redirector Apps Note Iss01.pdf on the CDROM

for more help.

Redirector config Notes: When configuring the TCPPort, enter a value of 10001,

ensure Raw Mode is enabled in Port Settings.

Note: At the time of going to press, NetPort is factory set to Local Port = 14001 and

will need changing by the user to 10001. See section: 4.4 Changing NetPort’s Serial

Parameters to connect to your Equipment

2. Use HyperTerminal-32bit (included in Windows Xp & Windows 2000) in Winsock

mode to connect over the Ethernet to the NetPort.

Note: At the time of going to press, NetPort is factory set to Local Port = 14001 and

will need changing by the user to 10001. See section: 4.4 Changing NetPort’s Serial

Parameters to connect to your Equipment

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

Nessun commento

Alpha Microsystems AM-649 Guida Utente Pagina 21